Perreaux ECD2 User Manual download pdf (Page 29)

Fuse Ratings

Mains input fuse

100 – 125V: ........................................................................ 2SB slow blow 0.5

200 – 250V: ........................................................................ 2SB slow blow 0.5

(user serviceable)

Weight

Net: ................................................................................................... 7.0kg (15.4lb

)

(CD player only)

Gross:.............................................................................................. 10.0kg (22.0lb

)

(CD player, accessories and packing material)

Specifications

Explained

Analog Rated Output ....................................................................................2.0V

RMS

This is the reference output level to which other specifications, such as signal to

noise ratio and total harmonic distortion, are referred.

Analog Output Impedance..............................................................................100

Ω

Output Impedance indicates the ability of the unit to drive the Line Leve

Output. The low impedance of the ECD2 means that it will drive an

combination of cable configuration (length, capacitance, etc.) and componen

impedance with ease whilst maintaining signal integrity.

Digital Output ................................................................................................... 0.5V

Indicates the peak-to-peak voltage of the signal from the digital output.

Digital Load Impedance...................................................................................... 75

Ω

Specifies the load impedance required for the coaxial digital interconnect.

Frequency Response ........................................................ 20Hz to 20kHz, ±0.5dB

Describes the frequency range where the amplitude or strength of the outpu

signal deviates from the source material by no more than 0.5dB

Total Harmonic Distortion

(THD+N)

.............................................. 0.004% @ 1kHz

Total Harmonic Distortion + Noise is the percentage of output signal which is

made up of frequencies added due to harmonics of the fundamental frequenc

and noise.

Signal to Noise Ratio...................................................................................... >105dB

The ratio of desired signal to noise signals present in the output. This figure is

referenced to the rated output of the CD player, taking into full account al

potentially annoying hum components.

Dynamic Range .............................................................................................. >100dB

The difference between the loudest and quietest portions of a signal. Due to th

increased dynamic range offered by HDCD encoding, this specification must b

greater than the 96dB limit inherent in the standard 16-bit CD format.

Channel Separation.......................................................................... 110dB @ 1kHz

Refers to the immunity of a signal from one channel leaking to the othe

channel. The higher the value, the better the isolation of the two channels.

1 2 ... 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Perreaux ECD2 User Manual Page 29

Comments to this Manuals

Related products and manuals for Musical Equipment Perreaux ECD2